Thanks for that tip! Stuff like that is what makes this forum great!Ĭlarifying for others: this is about the e-drum MIDI settings, not the e-drum Controller Type, which should be left to Default for SD. Yeah, I checked out the e-drum MIDI settings once but didn't notice anything different on my toms and snare and never bothered with it again.īut after reading this, I tried again and gosh darnit, you're right: it's the hihat that is massively improved! I thought it was fine before, but as you say, there's a whole range that I wasn't getting before. The edrums setting in solo is really only intended for ezdrummer. Monospace - if you don't use the edrum preset hihat performance will be choppy and you will lose the intermediate samples when you play.Do you have 'edrums' selected in solo? If that is the case then the remapping will be done before it gets to Superior.This is not the recommended method however as you get a lot more versatility by using S2's remapping. I do agree that it would be useful to be able to set and forget a default MIDI map, but I also know that there are reasons why this may not be desirable.good news ! but why the check mark of edrums mapping disappears when we reload a combined preset ? I do agree that it would be useful to be able to set and forget a default MIDI map, but I also know that there are reasons why this may not be desirable. You will also get snare positional sensing with the edrum preset if your module supports it. This enables you to access tight closed to fully open hihats and all the degrees of openness in between.
The most important part of this remapping is the hihat notes which will be remapped to either hatstrig or hatstiptrig.
When you then select the edrum preset, notes are remapped within S2 to fit most edrum setups. If you save a regular or combined preset the mapping will be saved with it (as long as you have MIDI ticked in the appropriate checkbox).so you don't need to load the edrum map every time.Īctually I would say my method is very useful as it allows you to keep your custom mapping when you load any other is the whole point of combined presets - to keep the settings you want to and select only the parts of a preset you desire.Ī factory S2 preset will have CC4 set as default.
0 kommentar(er)
